ASA Extraflex – pre-mixed acrylic based, flexible ceramic tile adhesive- Technical Data Sheet
Extraflex is a pre-mixed acrylic based, flexible ceramic tile adhesive suitable for most
interior wall and floor* applications. Extraflex is safe to use, non – toxic, easy to spread,
even on vertical surfaces, and because of its initial grab, tiles adhere immediately.
Extraflex has a long open time for tile adjustments which makes it convenient for the
tradesman or handyman. Extraflex is suitable for use in areas as specified by the
Australian Standard AS3958.1-1991 clauses 188.8.131.52;184.108.40.206;220.127.116.11;18.104.22.168;22.214.171.124;
FEATURES AND BENEFITS RECOMMENDED FOR
Flexible • Concrete
Easy to use • Cement render
Easy to spread • Sand/cement screeds
Water clean up • Fibrous cement sheeting
Low odour • Plasterboard
All surfaces must be clean, dry, and be free from dust, grease, wax, oil, laitance, curing compounds, paint, friable
material and all other contaminants that are likely to prevent the adhesive bonding. Building boards must be fi xed
in accordance to manufacturer’s printed directions. Cement render must be allowed to cure for 7 days, concrete to
be left with a wood fl oat fi nish and allowed to cure for at least 28 days. Porous or dusty surfaces must be primed
with ASA Multiprime prior to tiling. Smooth steel trowel fi nished concrete must be mechanically abraided to
Movement joints should be incorporated in the tile layout in accordance with AS3958.1-1991 clauses 126.96.36.199 to 6.
Apply the adhesive to the prepared substrate using the appropriate notched trowel for the size of the tile being laid.
Push tiles into the adhesive before it skins over. At least 80% of the adhesive must be in contact with substrate and
tile. Allow at least 24 hours before grouting.
Use the appropriate ASA grout, allowing joint widths of 1.5mm to 6mm for walls as per AS3958.1-1991 clause
Extrafl ex is suitable for use over concrete, sand/cement screeds and fi brous cement sheeting. Adhesive drying
time may be signifi cantly delayed, or a full cure may not be achievable under the following circumstances:
Dense or non-porous substrates
Dense or porcelain tile
Extrafl ex can be removed from the surface of the tiles using a damp cloth while the adhesive is still wet. Tools and
equipment can be cleaned with warm water and detergent prior to the adhesive drying.
20 litre,10 litre and 4 litre plastic pails.
Using a 6mm x 6mm notched trowel, 1 litre will cover approximately 1m² on a true fl at surface.
Technical Data Sheet
FREEPHONE: 0508 222 777
FREEFAX: 0508 222500
148 Pavilion Drive
Air Park II
(off Montgomerie Road)
telephone: 09 257 3580
facsimile: 09 257 3589
Victorian Head Office
51-71 High Street Thomastown Victoria 3074
Tel: +613 9279 9333 Fax:+613 9279 9270
New South Wales Office
21 Tattersall Road, Kings Park NSW 2148
Tel: +612 8825 3488 Fax: +613 8825 3411
660 MacArthur Avenue Eagle Farm QLD 4009
Tel: +617 3260 2206 Fax: +617 3260 2123
South Australia Office
23 Pambula Street, Regency Park SA 5010
Tel: +618 8244 0511 Fax: +618 8244 0522
Western Australia Office
12 Thorpe Close Welshpook, WA, 6016
Tel: +618 9258 6218 Fax:+618 9258 7687